If you are a first time homeowner or maybe someone who has just moved out of Mom and Dad’s humble abode, you may not know a lick about plumbing, but there are certain things that you should know. This article will discuss some of them, and you will be more knowledgeable after reading the tips below.
If you have issues with the plumbing making a hammering sound when you turn it off, check your water pressure. Any time your water pressure is above 80 PSI, you will hear extra water noise. This can be easily solved by the installation of a pressure-reducing valve, which can be done by most homeowners.
To winterize a house that will sit unused during the winter months, you must completely drain all of the pipes. After turning off the main water supply, let all of the water drain from the faucets, toilets, and water heater (turn off the gas). Add a quart of antifreeze to sinks and the tub to prevent water from freezing in the drain trap.
Certain things shouldn’t go into your plumbing system. By knowing what you can and cannot flush or throw into the garbage disposal and sink, you can save yourself from a costly repair or disaster. A plumber can usually get your plumbing back into working condition, but can be avoided if you know how to dispose of items correctly.
Make sure overflow holes are cleaned out. This can help to prevent any water damage. Overflow holes are a way to stop water from overflowing if a sink is left on by accident. If the overflow hole is clogged it will not be able to do its job.
Install screen traps or drain covers on all of your sinks and tub drains. Most home plumbing calls are about clogged pipes. These can be caused by debris, especially hair, washing down the drains. Putting in a trap means that you can clean this debris off before it ends up in the pipes.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Now that you have read these plumbing tips, you should feel a little more comfortable about looking after that scary hardware that lurks in some rooms of your home. Follow the advice above and you are sure to do the right things when tinkering around with any of the pipes.…