If you’re a home owner unfamiliar with plumbing, you’re probably familiar with the experience of being charged an arm and a leg for what seems like a simple plumbing repair. If you’d like to avoid this experience again, read on for some advice and tips on how to fix your own plumbing.
Roots from a tree in your back yard can be a real headache when it comes to plumbing. Make sure if you have a big tree or bush or some kind of plant with a big root system, that you ask your plumbing company about root killing agents. You can flush these down your toilet and kill any roots that may be blocking your pipes and save yourself a lot of money by stopping a back up before it happens.
To help you find a good plumber, you should get recommendations from people whom you trust. Asking a friend or a neighbor is usually more trustworthy than picking a random plumber out of the phone book. You need a competent plumber, otherwise you could be in for a much bigger problem down the road.
Use a hairdryer to thaw frozen pipes, after you shut off the water to the house. A hairdryer will gently heat the pipe and thaw the ice without causing significant damage to the pipe. Shutting off the water first means that if the pipe is broken, there will be no rush of water into the house.
Use strainers in all drains to catch hair and other objects. This will prevent all the material from going down the drain and causing a clog, which can cause a bigger problem down the line. Clean out the strainers daily so that you don’t start getting backup of water in your sink or tub.
Avoid using hard cleaners on your toilets, such as drop-in cleaner tabs in the tank. When these tabs are almost completely dissolved, what’s left of the tab gets washed into the bowl. This can then end up clogging the toilet’s port holes, preventing the toilet from flushing properly. It can take months for this debris to finish dissolving in those holes.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Plumbing isn’t as hard as it can seem, when you have access to good information and advice about how to go about solving your own plumbing problems. Next time you have plumbing problems in your house, try applying the tips from this article and see if you can save some money by solving it yourself!…